Singer 758 Sewing Machine Instruction Manual
$4.99
This is a download manual. Please check your email after purchasing.
Description
Singer 758 Sewing Machine Instruction Manual.
Includes:
Threading machine.
Bobbin winding.
Upper and lower tension adjustment.
Choosing needle and thread.
Adjusting stitch lengths.
Chain-stitching.
Fashion and Flexi-stitch disks.
Zigzag.
Buttonholes.
Flower embroidery.
Sewing knit and stretch fabrics.
Zippers.
Performance checklist.
Much more!
78 page instruction manual.
Touch and sew machine.
Singer 758 Sewing Machine Instruction Manual
Changing the bobbin
Removing the bobbin
Raise needle to its highest position.
1. Open slide plate; leave bobbin push it button in sewing position.
2. Raise bobbin and latch by inserting fingernail under end of latch at center of bobbin.
3. Insert fingernail under rim of bobbin immediately to the right of latch and remove the bobbin.
Replacing empty bobbin.
1. Make sure bobbin halves are securely tightened.
2. With latch raised, slip bobbin (wide side up) into bobbin case. Then snap latch down to secure bobbin.
3. Leave the slide plate open until you have finished winding.
Removing thread from bobbin
If there is not much thread left on the bobbin, you do not need to remove bobbin from machine simply pull the thread and through the throat plate.
If there is a lot of thread left and you do not wish to reserve it by setting aside the bobbin for future use, remove the bobbin, unscrew the two halves, and remove all the thread at once.
Replacing a wound bobbin
Raise needle to its highest position.
1. Open slide plate; leave bobbin push button in sewing position.
2. Draw 3 to 4 inches of thread from the bobbin and place bobbin in case with thread leading off to the right of the latch.
Snap latch down to secure bobbin.
3. Close slide plate, allowing the thread to enter the slot in the slide plate. Then raise the bobbin thread.
Raising the bobbin thread
1. Hold needle thread lightly with left hand and turn hand will slowly toward you so the entire needle enters throat plate.
2. Continue turning hand wheel until needle rises and brings up bobbin thread in a loop.
3. Undo the loop and place both threads under the pressure foot, laying them diagonally to the right. Position needle and fabric where desired, lowering the presser foot and stitch.