Singer 630 Golden Touch and Sew Instruction Manual

$4.99

This is a download manual. Please check your email after purchasing.

SKU: 196 Category:

Description

Singer 630 Golden Touch and Sew Instruction Manual

Examples include:
Threading the machine.
Winding the bobbin.
Regulating pressure.
Accessories and presser feet.
Machine settings.
Fashion disks.
Buttonholes.
Embroidery and stretch stitch.
Cleaning and oiling machine.

84 pages of great information.

Great diagrams!

 

 

Positioning the needle on your Singer 630 Golden Touch and Sew machine

The need rises to the up position every time you remove pressure from the speed controller.
You do not have to turn the hand wheel to position the needle for pattern selection, threading, or removing fabric.

If you wish to place the needle in the down position as when pivoting the work on the needle, remove all pressure from the speed controller and turn the hand wheel towards you.
However, before turning the hand wheel wait a few seconds after removing your foot or knee from the speed controller.

This slight delay allows the needle positioning cycle to be completed.
If you turn the hand wheel too soon, the needle will return to the up position.

After you have again started the machine by pressing the speed controller and then stopped it by removing the foot or knee pressure, the needle will stop in the up position.

 

 

Threading the needle

Make sure the needle is in its highest position.
1. Raise the presser foot.
2. Leave thread through all threading points as shown.
3. Thread needle from front to back, drawing about 4 in of thread through the eye of the needle.

 

Threading the needle with built-in threader

1. Draw approximately 5 inches of thread through the threading points on the machine.
Then lower the presser bar and make sure the needle is in its highest position.

2. Open face plate and release needle threader from its storage position by gently pulling it away from the holding pin and lowering threading arm in line with the needle.

3. Position aligning slot in threader arm over positioning screw on needle clamp, bringing threader hook and guides behind the needle.
Pull tab toward you so that the upper and lower hooks guide straddle the needle one on either side and the threading hook comes through the eye of the needle.

4. Place thread across the threading hook, keeping two to three inch of slack thread to the right of the hook and 1 to 2 inches to the left.
Withdrawal Hook from needle eye by pushing threader arm gently back and to the left.

5. Released red from Hook carefully and returned threader to storage position behind face plate.
Be sure aligning slot in thread your arm fits into holding pin.

6. Close face plate.

 

Singer 630 Golden Touch and Sew Instruction Manual

 

Singer sewing machine manuals

Reviews

There are no reviews yet

Add a review
Currently, we are not accepting new reviews