Necchi 6015 Omega Sewing Machine Instruction Manual

Description

Necchi 6015 Omega Sewing Machine Instruction Manual.

Includes:
Threading machine.
Changing the needle.
Bobbin winding.
Adjusting thread tension.
Dropping the feed dogs.
Reverse stitch lever.
Stitch length dial.
Two way speed control.
Sewing buttons.
Zigzag stitching.
Needle chart.
Sewing light.
Buttonholes.
Zipper application.
Drive belt tension.
Troubleshooting.
Cleaning.
Much more!

48 page instruction/owners manual.

Necchi 6015 Omega Sewing Machine Instruction Manual

 

Additional Necchi manuals here

 

 

 

Changing needles

Raise the needle by turning the balance wheel toward you and lower the presser foot. Turn off the power switch.
Loosen the needle clamp screw by turning it towards you.
Remove the needle from the clamp.
Insert the needle into the needle clamp with the flat side away from you.
When inserting the needle into the clamp, push it up as far as it will go and tighten the clamp screw firmly with the screwdriver.

 

Winding the bobbin

Lift up the spool pin. Place the spool of thread on the holder with the thread coming off the spool as shown.
Attach the large spool holder pressing it firmly against the thread spool.
The small spool holder is used with narrow or small thread spools.

 

Additional Spool Pin

The additional spool pin is used to wind extra bobbins without unthreading the machine.
To use, insert the additional spool pin in the hole. Place the felt and the spool on the pin.

 

Remove the bobbin

Gently push down the slide plate and pull it out onto the extension table.
Lift out the bobbin.

 

Threading the bobbin Winder

Pull the clutch knob away from the machine to disengage clutch.
Draw thread from spool. Hold the upper thread with both hands as and press it downward against the hook until it comes down under the hook. Guide the thread around the bobbin winder thread guide. Insert the thread through the hole in the bobbin, threading from the inside to the outside. Put the bobbin on the bobbin winder spindle and push it into the right.
With the free end of the thread held in your hand, depress the foot control.
Stop the machine when it has made a few turns, and cut the thread close to the hole in the bobbin. Depress the foot control again. When the bobbin is fully wound, it will stop automatically.
Return the bobbin winder to its original position by moving the spindle to the left, and cut the thread.
Push in the clutch knob to engage the clutch.
The machine will not sew until the clutch knob is pushed in.