Singer 776 Stylist Sewing Machine Instruction Manual

Description

Singer 776 Stylist Sewing Machine Instruction Manual.

Includes:
Threading your machine.
Bobbin winding.
Choosing needle and thread.
Threading bobbin case.
Needle threading.
Tension adjustment.
Adjusting dials.
Presser foot lifter.
Free-arm sewing.
Hints on special fabrics.
Zigzag sewing.
Straight stitch.
Decorative stitches.
Sewing knits and stretch fabrics.
Buttons.
Free-motion sewing.
Replacing slide plate
Replacing the light bulb.
Accessories.
Much more!

72 page instruction/owners manual.

 

 

Winding the bobbin – Singer 776 Stylist Sewing Machine Instruction Manual

Preparation
It is best to wind the bobbin before you thread the machine.

1. Turn hand will until needle is at its highest position.

2. Disengage hand wheel by loosening the hand wheel knob with your right hand while holding the hand wheel with your left.

3. Open the slide plate.

4. Lift out the bobbin.

 

Winding steps

1. Place thread spool on spool pin over the spool pin felt. Lead thread between tension discs around thread post and through small hole in the bottom from the inside out.

2. Place bobbin on spindle and engage latch by pressing it toward the bobbin.

3. Hold thread end and start the machine. Break off thread and when winding is well under way.

4. When required amount of threat has been wound, disengage bobbin latch. (full bobbin will automatically release). Cut thread and remove bobbin from spindle.

5. Tighten hand wheel knob by turning it away from you with your right hand while holding the hand wheel with your left hand.

 

Threading the bobbin case

1. Hold bobbin and so that the thread unwinds in the direction shown, and put bobbin in bobbin case.

2. Pull thread into notch in bobbin case, drawing under the tension spring and into slot.

3. Draw approximately 4 inches of thread diagonally across the bobbin.

4. Close slide plate, allowing the thread to enter the slot in the slide plate.