1. Raise take-up lever 5 to its highest point.
2. Place spool of thread on spool pin at top of machine
3. Pass thread through thread guide 1
Down, under and from right to left be tween tension discs 2 ( thread guard J, Fig. 9 guiding thread between discs).
4. Hold spool tightly and pull thread against take-up spring 4 until it enters retaining fork 3
5. Pass thread from right to left through hole 5 in take-up lever
Down through guide 6 on face plate Into guide 7 on needle bar bushing Into guide 8 on needle clamp
From right to left through eye 9 of needle. Draw about two inches of thread through eye of needle with which to start sewing.
