Singer 900 Futura Sewing Machine Instruction Manual

Description

Singer 900 Futura Sewing Machine Instruction Manual.

Includes:
Threading machine.
Choosing needle and thread.
Bobbin winding.
Regulating thread tension.
Fabric pressure adjustment.
Removing and replacing bobbin case.
Stitch length.
Using flexi-stitch patterns.
Buttonholes
Chain stitching.
Using built-in stitches.
All about Zigzag stitches.
Changing light bulb.
Cleaning your machine.
Performance check list.
Removing machine from cabinet.
Much more!

Great diagrams

70 page instruction manual.

 

 

 

Winding the bobbin – Singer 900 Futura Sewing Machine Instruction Manual

You will find a bobbin in place under the slide plate of your machine. To open slide plate, simply draw a gently towards you. If the bobbin runs out of thread during sewing, you can rewind it without removing it from the machine. The window in the slide plate lets you see the bobbin thread supply at a glance, to help avoid running out of thread in the middle of a seam.

 

Preparation steps

1. Raise the take-up lever to its highest position by pressing lightly on the speed controller or by turning the hand will toward you.

2. Raise the presser foot to release tension discs.

3. Open slide plate and make sure bobbin is empty.

4. Set pattern selector release lever by turning it clockwise and set stitch control dials for straight stitch stitch pattern needle position center and stitch width.

If pattern selector release lever fails to lock into place, turn the hand wheel slightly towards you and then reset lever.

 

Winding steps

1. Move bobbin latch to right (wind position).

2. Draw needle thread back between toes of presser foot, under left side of presser foot, then up, into and around thread retainer, as shown. Do not hold thread end. Start the machine, running it at a moderate speed.

3. Pull thread in away after it has separated from bobbin.

Keep your eye on the bobbin as it fills, do not allow thread to wind beyond the outside FULL ring.

4. Close slide plate to release bobbin latch to sewing position.

To start selling, pull thread back under presser foot and cut. Place threads diagonally under foot to right or left side, position needle in fabric where desired, lower presser foot, and start machine.